Saturday, May 14, 2011

Chapter 19 - Wings - Part 19

Since my last update I have completed installation of the right wing aileron and nearly completed the left wing aileron.

Today Marc and I loaded the wings and center spar into his truck and headed down the street to my work supervisor, Pete's, house, where he has a nice 3 car garage. We proceeded to level the wings on 6 of the cheapest crappiest saw horses I have ever used. I purchased 4 of them a couple of days earlier. Coincidentally Pete also had two of them on hand as well.

Finally after dropping the center spar on the floor of the garage once, we managed to get the wings set up pretty stable and level. We used standard bubble levels, Marc's laser level and a water level to ensure the wings were set up correctly.

We then proceeded to match drill through the center spar into the wing attachment points. I started out using the spot face tool as described in the plans, however that was a very slow process and I managed to burn up my drill. We then switched to a 5/8" bi-metal hole saw that I purchased today as advised by Marc, who probably did a lot of research into the procedure than me.

In the end all went quite well and I am very happy with the results.