After I cut the holes I gouged out some foam, I then filled in the void with flox to make a nice sturdy edge.
Completed headrest.
Foam routed out for flox reenforcement
map holder in action
Beverage holder?
Monday, March 10, 2008
Chapter 7 - Seat belts and rollover - Part 2
This weekend I assembled the headrest. After glassing I cut out map hole and the round hole at the back of the headrest. After searching all over my shop the only round thing I could find that matched the size of the hole called out in the plans was the bottom of a mixing cup (I have to wonder if this is just a coincidence).
After I cut the holes I gouged out some foam, I then filled in the void with flox to make a nice sturdy edge.
Completed headrest.
Foam routed out for flox reenforcement
map holder in action
Beverage holder?
After I cut the holes I gouged out some foam, I then filled in the void with flox to make a nice sturdy edge.
Completed headrest.
Foam routed out for flox reenforcement
map holder in action
Beverage holder?
Subscribe to:
Post Comments (Atom)
Posts
No comments:
Post a Comment